Aluminum veneer, as a commonly used decorative material, can be seen almost everywhere in many places, such as exterior wall panels, interior walls, ceilings, etc.

Today, the editor from the aluminum veneer manufacturer would like to introduce to you the specifications and thickness of aluminum veneer, hoping to help you as a reference when choosing.

The thickness of aluminum veneer mainly adopts 1.5mm, 2.0mm, 2.5mm, and 3.0mm plates, and the cost of aluminum plates with a thickness less than or greater than this thickness increases on the basis of normal cost.

The thickness of aluminum veneer curtain walls mainly uses 2.0mm, 2.5mm, and 3.0mm panels. There are 4.0mm and 5.0mm thick aluminum panels on the market, but the ordering time takes about 20 days, and the cost of ordering materials will increase (the processing cost of aluminum ingots into aluminum panels will increase).

Due to equipment and cost considerations, aluminum curtain wall panels with a minimum length and width exceeding 1400mm after unfolding are considered ultra wide panels, and the cost will correspondingly increase.

When ordering aluminum veneer materials, additional costs are required and the ordering time is long. In terms of price, when the width is between 1401 and 1500mm, the price will increase by 10 yuan/m2. For every additional 100mm, the price will increase by 10 yuan/m2,

Prices vary slightly among different manufacturers. The length cannot exceed 4 meters, otherwise the flatness will be affected and the processing equipment requirements will be higher. Currently, the longest bending equipment in China can bend a length of 6 meters.